span8
span4
span8
span4
Hello,
What is the trick to create a polygon from a set of coordinates and make sure FME read the points in the order to create the required polygon where _result field can be used as ID and acknowledge the order in which polygon should be created?I went thru a bunch of transformers,but I did not succeed with any...I went thru several articles from the knowledge center as well,but cannot figure it out.Hope the question makes sense.
Thank you for your inputs,regards.
Have a try at this sequence:
Sorter (sorting by _result if needed)
VertexCreator (create points from the coordinates,set to Add Point).
At the end this will create a line from the coordinates.
If the line is not a closed line,use LineCloser to connect last to first point.and create an area.
If the line is closed,use the AreaBuilder to create a polygon from the line.
© 2019 亚搏在线Safe Software Inc |法律