span8
span4
span8
span4
Hi
I have a spreadsheet (see table below) with a start and end point coordinates for different road sections and I'm trying to extract the road segments between the start and end points from another dataset containing my road geometry.Unfortunately the start and end points do not always lie on the road so I would need to snap it to the closest road.The road directions (road ways) are stored as separate features in the dataset with a common road id.
Section Id | Start Lat | Start Long | End Lat | End Long |
A | -33.938... | ,151.151. | -33.935... | 151.131…… |
B | -33.949... | 151.138.. | -33.931... | 151.154... |
C | --- | --- | --- | --- |
E.g.For SectionB,I want to extract the two segments in green from the underlying blue road.The eastbound (EB) and westbound (WB) road features have a common road id of 1.
I tried using two vertex creators,a point on line over layer,a topology builder and feature merger,but I haven't had too much success.
Any ideas on how this could be achieved?
Hi mkov,
I found a method that works for 2 points and 1 road.So it should work for the road with ID 2 and also for one segment for the road with ID 1.
I tried this using created a sample.Can you try this method on your data to see if it works?
I am not entirely sure the 'select only 1 segment'-part is the most efficient one but it works :)
FME Inspector:
FME Workbench:
If each line can be spatially related to just 2 points (start point and end point belonging to the same section),this data flow might work.
I implemented this method to find out how it works but I cannot find out what should happen with the MeasureExtractor:2 in combination with the StatisticsCalculator since the attribute '_point_measure' is empty when testing with my testdata.
Could you confirm if the result of the MeasureExtractor:2 should be the following?
For every point,the _point_measure should be the location of this point on the line.By calculating the mean of these two values,you make sure the result is a value between those two locations.That is why you can use this information in the Tester.Is this correct?
The ability to set measure to points of the PointOnLineOverlayer is relatively new (maybe FME 2015.1+?).Which version of FME are you using?.
I was working in build 15250 and it didn't work.In build 15482 it does.
Thank you!
Completely different approach flashed.Assuming that each line can be split into three parts by a pair of two points representing a section,the middle part is the required one.
1.Once connect the three parts with the LineJoiner.
2.Split the resulting line (path) into three parts again,with the PathSplitter.
The segment having 1 as "_segment_number" is the middle segment.
@jeroenstiersI haven't been able to get the point on line overlayer to work correctly.I'm not sure what I'm missing.
Because the PointOnLineOverlayer doesn't snap the end nodes of split lines to the input points,the output lines and points may not construct a network topology.
How to add measures to a line using another line/route with measures?3 Answers
How do I find the closest point object to a line objects start and end node (vertex)8 Answers
Extract line segment between two points3 Answers
Find paralel lines1 Answer
How to compare attribute to attributes within a list?1 Answer
© 2019 亚搏在线Safe Software Inc |Legal